You are here: Restoration > Restoring files only

Restoring files only

Use these instructions to restore specific volumes, directories, and/or files.

  1. From the Replication Console, select Tools, Restoration Wizard.
  2. Review the Welcome screen and click Next to continue.

    At any time while using the Restoration Wizard, click Back to return to previous screens and review your selections.

     

  3. Select the target that contains the copy of the data that you want to restore and click Next.
  4. Select the original source or Alternate, if your original source is not listed. This option identifies to the target which data set you are trying to restore so that the appropriate replication sets can be presented to you.
  5. Click Next to continue.
  6. Specify if you want to use an existing replication set or create a new one. This replication set will be used to connect from the target to the source.
  7. Click Next to continue.
  8. A tree display appears identifying the data available for restoration. Mark the check box of the volumes, directories, and/or files you want to restore. Keep in mind that if you exclude volumes, folders, and/or files, it may compromise the integrity of your applications or data.
  9. Click Next to continue
  10. Select the new source server. This is the server where the data from the target will be restored. This may be the original source server or a new server. Click Next to continue.
  11. Select your network route to the new source, which includes the IP address and port number. Also select the location on the new source for the restored data. If you want to set a customized path, click in the field under Source Path to edit the location.

  12. Click Next to continue.
  13. Specify the restoration options that you want to use.

  14. Review your selections and click Finish to begin the restoration.

After the restoration connection is established, you can right-click on it to access the Connection Manager and advanced connection options. If you selected to Replicate data during the restoration connection, the connection will remain in place, replicating any data changes, until you manually disconnect it. When you disconnect it, the replication set created for the restoration connection will automatically be deleted. If you did not select to replicate data, the restoration connection will automatically be disconnected and the replication set deleted when the restoration mirror is complete.